G5.2W, G2.2W, A4.2W, A1.2W - Page 21
Pin 12
GREEN WIRE
: Negative Door Input (-). Connect to the door switch circuit wire that shows ground
when the door is open.
Pin 13
WHITE/BLACK WIRE
: Hood/Trunk Pin Input (-). Connect the to the hood/trunk pin switch. The
switch must provide a ground output when switch is opened.
Pin 14
ORANGE WIRE
: Armed Output (-) 500 mA. The Orange wire provides a ground output while armed
to activate a relay for starter defeat and anti-grind protection or window rollup module.
Pin 15
VIOLET/WHITE WIRE
: Factory Disarm Output (-) 500 mA. The Violet/white wire provides a ground
output on disarming and before remote starting to disarm a factory security system. Connect to the
wire that requires a ground pulse to disarm the factory security system.
Pin 16
WHITE/VIOLET WIRE
: Auxiliary 3 / Factory Rearm Output / Ignition 3,(-) 500 mA. Programmable
Factory Rearm Output: provides a ground output on remote start shutdown to rearm a factory security
system. Connect to the wire that requires a ground pulse to rearm the factory security system.
Pin 17
BROWN WIRE
: Siren Output (+) 3A. The Brown wire must connect to the siren’s red wire. The Black
siren wire must be grounded.
Pin 18
GRAY WIRE
: Auxiliary 1 Output (-) 500 mA. Connect to a relay for an optional feature such as trunk
release, etc.
This output may be programmed for momentary, timed, or latched operation.*
Pin 19
WHITE WIRE
: Parking Light Output (+/-) relay. Connect the White wire to the circuit that shows
+12V or ground only when the parking lights are on and set the internal parking light relay jumper to
the proper polarity. For parking light circuits exceeding 10 amps, a relay is required. For vehicle’s with
independent left and right parking light circuits, diodes must be installed to keep the circuits separate.
NOTE: Do not connect the WHITE wire directly to the vehicle’s headlight circuit.
Pin 20
BROWN/WHITE WIRE
: Horn Output (-) 500 mA. Connect to a relay to activate the vehicle’s horn
when the alarm is triggered.
Plug-in Connectors
4-Pin White Connector:
Dual stage shock sensor port.( Can Also be used for optional Sensor, Radar, Glass, etc)
· WHITE WIRE: (-)Warn-Away Input For Optional Sensor. (G2, A1, Three (-) pulse starts and shuts off engine)
. BLUE WIRE: (-)Trigger Input For Optional Sensor. (G2, A1, one (-) pulse starts and shuts off engine)
· RED WIRE: (+) 12 volt Output For Optional Sensor.
· BLACK WIRE: (-) Ground Output For Optional Sensor.
2-Pin Blue Connector:
Valet switch port. plug the blue connector from antanna harness into this port.
2-Pin Red Connector:
LED port. plug the red connector from antanna harness into this port.
3-Pin White Door Lock Connector:
Door lock port.
· BLUE WIRE - negative unlock output (-) 500mA.
· GREEN WIRE - negative lock output (-) 500mA.
