Scytek electronic Astra 1000RS Series, Product Manual

3.  Press Button 1 on the first transmitter.

· The parking lights will flash once.

4.  Press Button 1 on the first transmitter again.

· The parking lights will flash twice to indicate it has learned the code.

5.  Repeat steps 3 and 4 for each transmitter (up to 4).  
6.  Turn off the ignition key.

· The parking lights will flash 3 times.  

To program 2-way LCD transmitter(s):

1. Turn the ignition key On, Off, On, Off, On, Off and back On·

.The parking lights will flash 4 times.

2. Press and hold the Override switch for 5 seconds. 

·The parking lights will flash 4 times and the LED will illuminate.

3. Press Button 1 on the first 2-way transmitter.

·The parking lights will flash twice to indicate it has learned the code.

4. Repeat step 3 for a second 2-way transmitter if applicable (up to 2)

Two Car Operation 

If two vehicles are equipped with the Astra Starter systems, for convenience both can be operated using
the same remote transmitter.  If all four transmitters are to be used with both cars, program transmitters
A and B into the first vehicle in the manner described above.  Program transmitters C and D by pressing
the Shift button twice before performing steps 3 and 4 above.  
When finished programming the first vehicle, program transmitters C and D into the second vehicle as

normal, then program transmitters A and B by pressing the Shift button twice before performing steps 3

and 4 above. 
When programmed in this manner, the driver of the first car can also operate the second vehicle by pressing

the Shift button twice and the desired function button. 

Battery Replacement

Your Astra Remote Transmitter uses a 12 volt alkaline battery (type 23A), which will require replacement in

time.  Depending on the amount of use, the battery may last up to six months or more before it needs

replacement.
When the battery needs replacing, the system’s operating range will decrease or the transmitter LED may

not be as bright.
In order to change the battery, first remove 2 screws from the back of the transmitter and separate the top

and bottom halves of the case.  
While replacing the battery make sure that the positive and negative terminals are positioned correctly, then

carefully reassemble the transmitter case.

Astra 1000RS Series  -  Page 3