Scytek electronic Galaxy 2000RS-2W, Product Manual

Galaxy 2000RS-2W  -  Page 9

Remote Starting

To Remote Start the System:

1.  Be sure the system is not in Valet Mode.

2.  Press and hold Button 4 for three seconds.

· The parking lights will turn on.
· The LED will flash rapidly.
· The engine will start and run for the duration of its programmed Run Time.*
· The heater or air conditioner will turn on (if turned on prior to exiting the vehicle).

*If the engine fails to start on the first attempt, it will repeat the starting procedure 2 more times.  If the vehicle

fails to start after a total of 3 times the parking lights will flash 4 times and the doors will lock (if installed).

Turn on the ignition and press the bake pedal to disengage the remote start feature and drive the vehicle.

Shut Down

When the the Remote Start feature is active, any of the following actions will shutdown the engine:

1.  Pressing Button 4.

· After the engine shuts down the doors will lock (if installed).

2.  Pressing the Brake Pedal.
3.  Opening the Hood.
4.  Remote Start Time-Out (completion of the timed run cycle).

Quick Stop 

The Quick Stop Feature allows you exit the vehicle while keeping the engine running for quick stops.
To leave the vehicle running:

1. While engine running Push Start Button on the Remote Transmitter until the parking lights flash.

· The parking lights will turn on.

2.  Remove the key from the ignition switch.
3.  You may now exit the vehicle and lock the doors manually or using the Remote Transmitter

To resume control of the vehicle:

1.  Unlock the doors manually or by pressing Button 4 on the Remote Transmitter*.
2.  Turn on the ignition.
3.  Press the Brake Pedal to disengaged the remote start.

*If optional keyless entry feature is installed.

Remote  Start  Features