Scytek electronic GALAXY 5100RS SERIES, Product Manual

Page 14 - Galaxy 5100RS 

3.  Press and release Button 1 on the first transmitter then on the second transmitter.

· The siren/horn will chirp/honk once for every transmitter learned.

4.  Turn off the ignition key.
5.  The siren/horn will chirp/honk 3 times to indicate the system has exited programming mode.

LCD Transmitter Battery Replacement

Your Galaxy Remote Transmitter uses a 1.5 volt AAA alkaline battery, which will require replacement in time.

Depending on the amount of use, the battery may last up to 3 months before it needs replacement. When

the battery needs replacing, the system’s operating range will decrease, the LCD display will show only one

of three bars in the battery icon, or the display and sounds may suddenly stop and start as the battery

voltage drops below minimum.

In order to change the battery, first slide the battery door locking pin to the side.  Carefully slide the battery

cover downward until it is free. While replacing the battery make sure that the positive and negative

terminals are positioned correctly, then carefully reassemble the transmitter case.

Setting The Time

The LCD display is equipped with a 12-hour clock that in addition to displaying the time, offers an alarm

clock function as well as a remote activation timer.

To set the time:

1. Press and hold Buttons 2 and 3 for three seconds.

· The remote will beep two times and three bars will be shown indicating time set mode is entered.

2. Press and release Button 2 until the correct hour is displayed. (hold button to scroll).

3. Press and release Button 3 until the desired minute is displayed. (hold button to scroll).

4. When the desired time is displayed, press Button 5 to store.

· The remote will beep 3 times to indicate the time has been set.

Setting The Alarm Clock

The alarm clock function can be set to play an alert melody at a specific time of day.
To set the alarm clock function:

1. Press and hold Buttons 2 and 3 until the remote beeps three times.

· The alarm clock bell and three bars will be shown indicating alarm clock set mode is entered.

2. Press Button 2 until the desired hour is displayed.
3. Press Button 3 until the desired minute is displayed. The button may be held down to scroll faster.
4. When the desired time is displayed, press Button 5 to store.

· The remote will beep 3 times to indicate the alarm clock has been set.

To disable the alarm clock function:

1. Press and hold Buttons 2 and 3 until the remote beeps three times.

· The alarm clock bell and three bars will be shown indicating alarm clock set mode is entered.

2. Press Button 1 to disable the alarm clock.

· The remote will beep 3 times and show OFF to indicate the alarm clock has been disabled.

Setting The Daily Start Function 

( transmitter must be within 1500ft to reliably start)

The Daily Start Function provides a timer that allows the vehicle to automatically remote start at a preset

time of day , everyday until the feature is turned off.