Scytek electronic P10 Series, Product Manual

Page 10 -  A10-4B

System  Wiring

8-Pin Main Harness

Pin 1

ORANGE WIRE

: Armed Output (-) 500mA.  The ORANGE wire provides a ground output while armed

to activate an optional starter defeat relay or other device such as a power window control module. 

Pin 2

BLUE WIRE

: Trunk/Hood trigger Input (-). Connect the BLUE wire to the trunk and/or optional hood

pin switches. The switch must provide a ground output when opened.  

Pin 3

BLACK/WHITE WIRE

: Dome Light Output (-) 500mA. Connect to an optional relay for dome light

activation. NOTE: The output from the optional dome light relay may usually connected to the same

wire used for the door trigger input (See GREEN and VIOLET door trigger wires).

Pin 4

BROWN/WHITE WIRE

: Horn Output (-) 500mA. Connect to an optional relay to activate the

vehicle’s horn when the alarm is triggered.

Pin 5

GRAY WIRE

: Auxiliary 1 Output (-) 500mA. Connect to a relay or module for an optional feature

such as trunk release, etc.

Pin 6

BROWN WIRE

: Siren Output (+) 3A.  The BROWN wire must connect to the siren’s red wire.  The

BLACK siren wire must be grounded.

Pin 7

GREEN WIRE

: Negative door trigger Input (-).  Connect to the door switch circuit wire that shows

ground when the door is open.

Pin 8

VIOLET WIRE

: Positive door trigger Input (+).  Connect to the door switch circuit wire that shows

+12V when the door is open.  This type of door circuit is usually found on Ford vehicles.

4-Pin Main Harness

Pin 1

WHITE WIRE

: Parking Light Output (+)10A.  The WHITE wire must connect to the circuit that shows

+12V when only the parking lights are on. For parking light circuits exceeding 7 amps, a relay is

required. For vehicle’s with independent left and right parking light circuits, diodes must be used to

keep the circuits separate. NOTE: Do not connect the WHITE wire to the vehicle’s headlight circuit.

Pin 2

RED WIRE

: +12V Battery Input (15A Fuse). The RED wire must be connected to a clean source of

cont12V power.

Pin 3

YELLOW WIRE

: +12V Ignition Input.  The YELLOW wire must connect to a main ignition wire at the

ignition harness. This wire must show +12V when the ignition is on.

Pin 4

BLACK WIRE

: Ground Input (-). The BLACK wire must connect to a solid chassis ground. Clean away

any paint or dirt to insure the best possible ground.   

Plug-in Connectors

3-Pin White Door Lock Connector: 

Plug-in connector port for door lock harness or optional door lock

relay module.

· BLUE WIRE - negative unlock output (-) 500mA.

· RED WIRE - co12V low current output for relay modules, or inverters.  100mA relay trigger

only.  Do NOT use as a power source for door lock relays.

· GREEN WIRE - negative lock output (-) 500mA.

2-Pin Red Connector: 

Plug-in connector port for LED.  Mount the LED in an area where it may be easily

seen from either side of the vehicle.

2-Pin Blue Connector: 

Plug-in connector port for valet switch.  Mount the valet switch in an area that is

easily accessible from the driver’s position.

4-Pin White Connector : 

Plug-in connector port for dual stage shock sensor.