P:\INSTALLATION INST\ACCESS CONTROLS\E75\INST-E75.vsd REV F 03-20 Page 4
Quick Start
Programming Instructions
E75
EntryCheck
TM
Test the Lock Operation
To test lock operation before initialization, enter
*741
. This temporary code will unlock the E75 for testing purposes.
Once a lock initialization has been performed, this code is no longer active until a hardware reset is performed which
will erase all the users and return the E75 back into the uninitialized factory default condition.
Prox Units
Only
User Programming
Add a User PIN Code (4-6 digits):
01# User No.# PIN Code # Pin Code # Group No.#
Example:
Press 01# 04# 5050# 5050# 06#
You have just added User #04 with a PIN of 5050 to unlock the door.
User 4 has been assigned to group 06 (24/7 access).
To Initialize Lock:
Press #9* 123456# 0001#
The above example enters a Lock ID of 0001. If multiple locks are used it is recommended that each lock
have its own
Unique
Lock ID (0002, 0003, etc.). This is required when using the E7 Management Software.
Lock Initialization
When the lock is first installed or after a factory reset has been performed, the E75 must be initialized with a 4-digit
lock ID before you will be allowed to enter programming mode.
NOTE: You must first enter programming mode to perform any other function. 20 seconds of inactivity will
automatically exit you from programming mode and return you to operational mode.
Test the lock by pressing 5050#, or present a valid prox card to the reader (prox units only).
Add a Sequential Batch of Cards:
08# Starting User No.# No. of Cards# Present 1
st
Sequential Card
Example:
Press 08# 05# 10# Present Card
You have just added (10) proximity card for User #’s 05 to 14.
All users has also be assigned to group 06 (24/7 access).
Add a Single Card:
06# User No.# Present Card
Example:
Press 06# 04# Present Card
You have just added a card to User #4.
User 4 has also be assigned to group 06 (24/7 access).
Exit Programming Mode: **#
Press **#
Enter Programming Mode:
Press #9# 01# 123456#
User 01 with default PIN Code 123456 is the administrator and has full programming rights.
For a complete list of lock programming functions, including programming for the E75KL/E75PL Privacy Lock, refer to
the E75 Programming Guide included with this lock.
