P:\INSTALLATION INST\ACCESS CONTROLS\E75\INST-E75.vsd REV F 03-20 Page 5
Resetting the E75 to Factory Settings
Warning!!
This procedure will preform a hardware reset and will erase all the users and custom settings returning the
E75 back into the uninitialized factory default condition.
1) Remove power (Unplug the battery pack)
2) Short and hold the 2 Brown Reset wires together
3) Apply power. (Plug in the battery pack)
The left LED will light RED for a few seconds, followed by a flashing RED/GRN. When initialization is complete, you will
hear 3 beeps.
4) Disconnect and insulate the Brown Reset wires.
5) Return to Page 4 of these instructions to initialize the lock.
Set Unlock Timer:
21# Seconds#
Example: Press 21# 03 #
Unlock timer is set for 03 seconds. (default)
Seconds
= 03-20
Beep on Key Press :
62# Status #
Example 1: Press 62# 1#
The E75 will beep each time you press a key.
Status
= 0 Disabled
1 Enabled (default)
Set the Date:
30# MMDDYY#
Example: Press 30# 011513 #
The date is set for January 15 th 2013
MM
= 2 digit Month
DD
= 2 digit Day
YY
= 2 digit Year
Set the Time:
31# HH MM#
Example: Press 31# 1320 #
The time is now set to 1:20 PM.
HH
= Hours (24hr format)
MM
= Minutes (24hr format)
Additional E75 Programming
Clear all Programming :
99# 000000 #
Example 1: Press 99# 000000 #
All user codes are erased and settings are set to factory defaults. The Administrator Pin Code and Lock ID are not cleared.
Delete a User:
02# User No.#
Example: Press 02# 04#
You have just Deleted User #04
Change a User PIN Code:
03# User No.# New PIN Code # New Pin Code #
Example 1: Press 03# 01# 123123# 123123#
You have just changed the Administrator’s Pin Code to 123123
NOTE: The Administrator’s PIN code must be 6 digits in length. All other PIN codes may be 4-6 digits in length
Example 2: Press 03# 04# 1220# 1220#
You have just changed User #04's Pin code to 1220
Set Entry Mode : 05# Mode #
Example 1: Press 05# 1#
Unlock the door either by entering a (PIN + #) or presenting card.
Example 2: Press 05# 2#
Unlock the door by presenting a valid card.
Example 3: Press 05# 3#
Unlock the door by presenting card plus the associated user code (PIN + #).
Mode
= 1 PIN or Card (default)
2 Card Only
3 Card AND Pin
Refer to the E75 Programming Guide for a complete list of lock programming functions.
