Any suggestions or comments to this instruction or
product are welcome. Please contact us through
our website or email engineer@sdcsecurity.com
P:\INST INSTRUCTIONS\ELR KITS\INST-LR100KWK-EM
REV B
08-22
Page 1
Remove End Cap, attach forked activation tab where shown and replace End Cap. Insert Fixation Plate into the device.
Slide the ELR assembly into the base channel raising it to allow for motor clearance above the device channel.
Depress the touchpad completely and slide the ELR unit in
over the forked activation tab.
Energize the ELR unit which will bring the rollers down
towards the activation tab.
LR100KWK-EM
KAWNEER ELECTRIC LATCH RETRACTION DEVICE KIT
MODEL: 1786 RIM DEVICE
Slide ELR under
Fixation plate
Fixation plate & set
screws
LR100-KWK-EM
REMOVE END CAP
Insert the forked activation tab between
the End Cap & the End Cap Plate using
existing screws
SECURITY DOOR CONTROLS ■ WWW.SDCSECURITY.COM
[t] 800.413.8783 ■ 805.494.0622 ■ E-mail: service@sdcsecurity.com ■ 801 Avenida Acaso, Camarillo, CA 93012 ■ PO Box 3670, Camarillo, CA 93011
INSTALLATION INSTRUCTIONS
Rollers
Activation Tab
