Version 5
page 32
Product Certifications
Electromagnetic Compatibility
This product meets the requirements of the following EMC standards for measurement, control and sensitive
electronic equipment used in laboratories.
•
EN 5032:2015/AC:2016
•
EN 55035:2017
•
EN 61000-3-2:2014
•
EN 61000-3-3:2013
FCC Compliance
This product meets the essential requirements of the applicable U.S. Directive as follows:
•
FCC Part 15 Subpart B, Class A
CE Compliance
This product meets the essential requirements of the applicable European Directives as follows:
•
2014/30/EU; Electromagnetic Compatibility Directive (EMC)
•
2011/65/EU; ROHS
•
2006/66/EC; Batteries and accumulators and waste batteries and accumulators
KC Compliance
This product proves that it has been registered in accordance with paragraph 2-3 of Article 58 of the Radio
Wave Act.(The Clause 3, Article 58-2 of Radio Waves Art.)
Battery
This product uses lithium ion batteries.
Do not use the product in environments where it can be wet or corroded. Do not store or place the product in
or near a heat source, in a high temperature environment, or in strong direct sunlight. Do not place in a
microwave or pressurized container. Also, do not expose to temperatures above 122 °F / 50 °C.
Failure to follow these instructions may result in acid leak, heat, explosion or ignition, causing injury and
damage.
Do not drill, open, or disassemble the battery. The battery will not charge at temperatures below 32 °F / 0 °C or
temperatures above 113 °F / 45 °C. Do not attempt to remove or remove the battery. If there is a problem with
the battery, contact Technical Support at SDT.
※
CAUTION: If the battery is not replaced with the correct type, there is a risk of the battery exploding.
The batteries contained in this product must be disposed of in accordance with local laws and regulations.
•
CEI 62133:2012
•
IEC/EN 62133:2017
•
UN 38.3(ST/SG/AC.10/11/Rev.6/Amend.1)
