Vigilant User Manual
195/232
Point
Selects from the pull-down list the dynamic point of the waveform that will be used for
the X-Axis in the orbit. Angle assignment and turning sense are indicated.
Proc. Mode
Selects the
Processing mode
of the waveform from the pull-down list.
Y-AXIS
Point
Selects from the pull-down list the dynamic point of the waveform that will be used for
the Y-Axis in the orbit. Angle assignment and turning sense are indicated.
Proc. Mode
Selects the
Processing mode
of the waveform from the pull-down list.
When using Orbits, it is highly advisable to define Components assigned to each couple
of points that will be used for the orbits, so that the system will be able to check the
correct angles assignments.
Field
Description
Filtering
Apply a filtering composition to the waveforms to extract the main rotational
components of the waveforms. A signal reference with any harmonic or sub-
harmonic value may be applied to calculate the filtered signal. Sub-harmonic
values are indicated by introducing a fraction in the form (only
rational
numbers
are valid).
Max cycles
Select a maximum number of rotating cycles to be displayed in the interface.
Max samples per
cycle
Selects the maximum number of sample points to show per machine rotating
cycle (in between two tachometer edges) when some type of Synchronous View
is selected.
