Vigilant User Manual
202/232
13.14.3.
Single cursor
The
Single
cursor is selected by default in this widget.
Clicking on any point of the graphs, this will show a pop-up window at the top right side of
the
Widget
with the following information:
•
t: timestamp of the capture.
•
L: Peak value of the parameter.
•
Angle: Phase value of the parameter.
•
(Compensate runout): Sets runout reference at this capture.
•
Speed: Speed of the machine at that capture.
•
State: State of the machine at that capture
•
Alarm: Alarm state of the machine at that capture.
Once the cursor is created clicking on the graph again will move the cursor into the corresponding
point of the graph. The cursor can also be moved by pressing on left and right arrows of the keyboard,
jumping from point to point of the orbit.
13.15.
Long Waveform
This
Widget
displays a long waveform capture, using an envelope view instead of the full waveform.
Different analysis tools allow decomposing this long duration signal, extracting spectra, parameters,
etc.
13.15.1.
Configuration
The following picture shows its configuration settings. Once the
Widget
is selected click on the shortcut
key “c” or the button in order to show its configuration form.
