Using Your SDX Telephone
Using Your SDX Telephone – Page
– Page 99
SDX 10/20/40E - FT-2/3/4 Terminal Guide
SDX 10/20/40E - FT-2/3/4 Terminal Guide
39HTN00
39HTN000026PEA - Issue 6 (April 1997)
0026PEA - Issue 6 (April 1997)
Changing From LD To MF Signalling
Changing From LD To MF Signalling
If switchable trunks have been fitted and set to LD, changing from LD to
MF signalling can be done by selecting an outgoing line and dialling .
Any digits dialled after will be signalled in MF. Once switched to MF,
the line will only revert to LD when the outside line is released.
Operator Using A Specific Outside Line
Operator Using A Specific Outside Line
Terminals with Operator status can also make external calls on specific
outside lines.
To make a call on a specific outside line
To make a call on a specific outside line::
1. Press Monitor
Monitor (normally button C
C).
2. Dial the line number (01
01 - 50
50) and wait for external dial tone.
3. Dial required external number.
4. When answered lift handset and speak.
Clear/Cancel Calls
Clear/Cancel Calls
To Clear a call
To Clear a call::
1. Replace handset or
or press Release
Release (normally button EE).
To Cancel an unsuccessful call attempt while remaining on-hook
To Cancel an unsuccessful call attempt while remaining on-hook::
1. Press H
H (FT2 only) or Release
Release.
If all exchange lines are busy, you will automatically join a queue for a
free line. The Camp On
Camp On symbol will be displayed. Wait for exchange dial
tone.
Tie Lines
Tie Lines
If your system is provided with Tie Line(s), you can call another site as if
it were an extension to your SDX.
To make a call on a Tie Line
To make a call on a Tie Line::
1. Dial 80
80 followed by the required number. When answered lift handset
and speak.
Other codes may also be available; ask your System Manager.
