Se-Kure
Controls,
®
Inc.
3714 Runge Street • Franklin Pk., IL 60131-1112 • 1-800-322-2435 • (847) 288-1111 • Fax: (847) 288-9999
www.se-kure.com • email: info@se-kure.com
Measures:
1-3/4 x 1-3/4" x 1-3/16"D
Wrench Shown
Actual Size
SK-4841
SK-99-404
SKP-100K
SK-4800RC-1
MicroMini
®
Alarm Instructions
Installing the MicroMini
®
Alarm
1. Locate and clean the surface where the alarm
will be mounted. Select a flat
surface for mounting. Clean
the surface with an alcohol
prep pad and wipe dry with a
clean paper towel.
2. R e m o v e
the carrier
paper from the
adhesive on
the bottom of
the unit and
press it firmly
into place on
the cleaned
surface.
3. Alternatively, you may use a screw to secure the
alarm.
Activating the Alarm
1. Place the SK-99-404 Removal Tool against the flat
spot on the lasso end and remove the pin end of the
wire.
2. Take the loose pin on the end of the wire and insert
it into the alarm where the label indicates “Insert Pin”
in red.
3. Push the pin
in as far as it
will go. When
inserted all the
way, the unit
will emit an
audible beep
and a light will
flash.
4. Remove the
pin. A red light will flash every 8-10 seconds to show
that the unit is armed.
Dry with Paper Towel
Clean with Alcohol
