3714 Runge Street • Franklin Pk., IL 60131-1112 • 1-800-322-2435 • (847) 288-1111 • Fax: (847) 288-9999
www.se-kure.com • email: info@se-kure.com
MicroMini
®
Alarm Instructions
Attaching the Cable End to a
Displayed Product
1. Wrap the alarm wire around the item to be protected
and insert the pin into the clutch.
2. A 90 decibel alarm will sound if the unit is removed
from the surface to which it is attached or if the retractor
wire is cut.
Adjusting the Length of the Alarm
Wire & Removal
1. Use the SKP-100K wrench to loosen the nut on the
clutch. Adjust the wire length to what you desire and re-
tighten the nut.
2. To remove the displayed item from the MicroMini
Alarm, place the SK-99-404 Detacher on the flat bottom
of the clutch and pull the pin free.
Loosen the Nut on
the Clutch
Pull to Tighten Lasso
2. If the remote control battery is expended, Use a Torx T10
Security Driver (Not Included) to remove the clear cover of
the alarm. Insert the point of a pin or ballpoint pen
into the slot that contains a small, black switch.
Push the switch towards the outer
edge of the alarm. That will
shut off the alarm.
Cancelling the Alarm
1. To use the remote control device, point the remote
VERY CLOSELY
at the flashing red LED and press the
button on the remote. The alarm should stop.
SK-4800RC-1
Pull the Cable
to T
ighten theLasso
SK-99-404
Detacher
SKP-100K
Wrench
Pull Out
Lasso
Torx T10 Security Driver
(Not Included)
SCI-1044
