Battery Test
AC/DC
Power
Supply
Jack
Remote Keyway
Jack
Horn
Assembly Instructions:
4
Sensor
Ports
The Alarm is now Ready & Active.
Additional Instructions:
1.
Your alarm is equipped with 4 ports.
If only one port is used on a
displayed product a shunt plug must
be installed into any unused ports. If
this is not done the alarm will sound.
2.
Prior to placing the sensor on the
product, the area where the sensor
is to be applied must be cleaned
with the alcohol wipe provided, then
thoroughly dried before attaching
the sensor.
3.
For the alarm system to function the
remote key must be plugged into the
alarm unit.
4.
When attaching the alarm to the
surface follow the cleaning instru-
tions for the sensor given in step 2
above.
Installation Instructions for the
4-on-1 Alarm w/Remote Keyway
Rev. 3/13/13
P# 62097 SCI-9983
©2013 Se-Kure Controls,
®
Inc.
3714 Runge Street
Franklin Park, IL 60131
1-(800) 322-2435
(847) 288-1111
Fax: (847) 288-9999
On the Web:
www.se-kure.com
E-Mail:
info@se-kure.com
Battery
Connector
Cover
Plate
Remote Keyway
Jack
9-volt
Alkaline
Battery
(Not
Included)
AC/DC
Adapter
Jack
Battery
Installation:
1.
Remove the (4)
phillips head screws
to open the battery
compartment as
shown in the
diagram.
2.
Attach a 9-volt
Alkaline Battery
(not included) to the
connector, and insert
the battery into the
compartment.
3.
Replace the
cover plate and the
(4) phillips head
screws.
Note:
Tighten screw
until it stops–
Do
Not Over-Tighten
Optional Battery Back-Up Installation
The 4-on-1 Alarm will operate normally without a battery, but will not alarm when
power to the SK-395M AC/DC Power Supply is interupted.
For Back-Up purposes when the circiut loses power, follow the optional battery
backup installation instructions below.
6.
Remove the backing sheet from
the other side of the adhesive pad
and position the sensor over the
flat area of the display product
previously cleaned. Press the
sensor firmly into place to insure
a proper bond.
7.
Following the important cleaning
steps, apply the base adhesive
to the alarm module and adhere
it to the display surface.
8.
Turn the key counter clockwise
to the “ON” position and remove.
