Se-Kure Controls,
®
Inc.
3714 Runge Street • Franklin Park, IL 60131 • 1-(800) 322-2435 • (847) 288-1111 • Fax: (847) 288-9999
Rev. 6/17/99
SCI-9615
©1999 Se-Kure Controls,
®
Inc.
Battery Installation:
8.
Remove the (4) Security Screw from
around the base of the Alarm Module with
the (SKP-416K) Security Allen Wrench.
9.
Lift and remove the cover of the
(SK-903KB) Alarm Module.
10.
Install (2) 9-v Alkaline batteries as
shown at right, and push firmly onto the
printed circuit board.
11.
Replace the cover and the (4) security screws, and then plug in the AC/DC Power Supply.
Note: The cover security screws must be installed and tightened to prevent the alarm from sounding.
Low Battery Power Alarm
Low Battery Light will (((flash))) and Alarm will “CHIRP” when
batteries need to be replaced.
(When replacing batteries, refer to the Keypad Operating
Instructions to place the system in the “Stand-By” Position before removing security screws).
Outdoors: (continued)
4.
Connect a (SK-947KB) Outdoor Product Cable to the (SK-907KB) Outdoor Splitter.
5.
Pass the cable(s) through an enclosed area of each product, (such as spokes, or steer-
ing wheels) to protect all the display merchandise in the line, as shown above.
6.
Thread the end of an (SK-947KB) Outdoor Cable
through the loop of a (SK-109KB) Terminator Loop, and
Lasso an enclosed area of the last product in line by
connecting the Terminator Loop and Cable Connector.
7.
Repeat the procedure for the other side of the
(SK-907KB) Outdoor Splitter.
Note:
If the other side of the Splitter is not in use, a Terminator
Loop needs to be in that connection to create a “Closed Circuit” in
the system.
Remove Security
Screws
SK-109KB
Terminator Loop
SK-109KB
Terminator Loop
SK-947KB
Outdoor Cable
Outdoor Display
Products
Outdoor Display
Products
SK-907KB
Outdoor Splitter
Last
Outdoor
Display
Products
Last Outdoor
Display Products
SK-109KB
Terminator Loop
