Installation Instructions for the
SK-584P
Vantage
II
Stand
w/Angled Sensor & Power Connection for T- Power Alarms
Se-Kure Controls,
®
Inc.
3714 Runge Street • Franklin Park, IL 60131 • 1-(800) 322-2435 • (847) 288-1111 • Fax: (847) 288-9999
Rev. 1
1
/
12
/09
SCI-9936
©2009 Se-Kure Controls,
®
Inc.
Optional Parts & Accessories
ASSEMBLY INSTRUCTIONS:
On the Web: www.se-kure.com
E-Mail: info@se-kure.com
1.
Remove the Security Screws
at the base of the Vantage II
Stand with the
SK-11-309
Handle
Driver &
SKP-190
Driver Bit or the
SKP-190T
Security Wrench.
2.
Remove the Base Plate
from the bottom of the
Vantage II Stand and
place it
over the hole
on the display.
3.
Mount the Base Plate to
the display
(Use the appro-
priate fasteners for your dis-
play surface).
4.
Plug the SK-122-PWR-25
Alarm cable into the phone
jack in the base of the
Vantage II Stand.
To find the Adapter for
your device, contact your
Se-Kure Controls
Customer Service
Representative.
Fits Driver Above
SK-585
Angled Sensor Adhesive
SK-PS-126-S
(shown)
Power Adapter
SKP-190
Security Screw Driver Bit
SK-11-309
Driver Bit Handle
SKD-584P
Vantage II Stand w/Angled
Sensor & Power
SK-122-PWR-25
2' Connecting Power Cable
SKP-190T
Security Wrench
SK-295P
12 Volt Power Supply
SK-T12P
T-12 Alarm Module w/Power
Follow the Battery
and Installation
Instructions that
come with your
Alarm Module.
Provides Power to the T-Series
Alarm & 5v to Connected
Devices
