Sea Clear Watermakers G-20, Installation Manual

❷

  Blow the tubing clear to eliminate any chips or dust created by cutting.

❸

  Once you’ve installed ends 

fi

 ttings on the high pressure tubing, connect tubing to the High Pressure 

Pump and Membrane using Te

fl

 on tape to seal the threads.

❹

  Install the high pressure tubing from the Membrane to the port on the Control Panel labeled “H.P. 

In.” Install end 

fi

 ttings per the “Swagelok High Pressure Fitting Installation” instructions. Connect 

and tighten 

fi

 ttings.

S

wagelok High Pressure Fitting Installation

❶

  Fully insert the tube into the 

fi

 tting and against the 

shoulder; rotate the nut 

fi

 nger-tight. Fig. 1.

High-Pressure 

A

pplications and High 

S

afety-Factor 

S

ystems:

    Further tighten the nut until the tube will not turn by hand 

or move axially in the 

fi

 tting.

❷

 Mark the nut at the 6 o’clock position. Fig. 2.

❸

  While holding the 

fi

 tting body steady, tighten the nut one 

and one quarter turns to the 9 o’clock position. Fig. 3. Note: 

For 1/16, 1/8, and 3/16 in.; 2, 3, and 4 mm tube 

fi

 ttings, 

tighten the nut three-quarters turn to the 3 o’clock position.

Sea Clear Watermakers™ Manual - Version 1.1-G 

Page 31