L
ow Pressure Hose
❶
Install a 1/2” hose run from the output of the Pre-
fi
lter Housing to the inlet
of the High Pressure Pump, securing with hose clamps.
❷
Install a 1/2” hose run from the Brine Dump port on the Control Panel to
the through-hull.
❸
Install a second hose run from the second Brine Dump port on the Control
Panel to the pressure relief valve located on the High Pressure Pump.
Product Water Hose
Install a 1/2” hose run from the product port on the Membrane
(see Figure 2 on page 28)
to the port on
the Control Panel labeled “From R.O.M.” and secure with hose clamps.
Through-Hull (not supplied)
The boat’s designated intake through-hull should be located in an area that will always be in the water
when the boat is used under normal running conditions. This through-hull must not be located near
discharge lines that could introduce foreign materials, such as head or generator exhaust.
• Because it is important that the product water line never become blocked, we discourage
the use of shut-o
ff
valves in the product water tubing.
• We recommend that the product water from your watermaker be connected to its own
fi
ll
on your water tank. However, as we understand this is not always possible and because all
installations are di
ff
erent, any solution that will not block the
fl
ow of water is acceptable.
Sea Clear Watermakers™ Manual - Version 1.1-G
Page 32
Though it may be necessary to “T” into another drain for the Brine discharge, it is preferable
that a new through-hull be installed speci
fi
cally for the watermaker. This through-hull should
be located above the waterline and in a spot where
fl
ow can be veri
fi
ed from on deck.
