3
User Supplied Items
Four (4) ¼” (6mm) screws or four (4) ¼” bolts with nuts
10A fuse and fuse holder
Two (2) #8 self-tapping screws
Four (2) 18
– 20 gauge butt connectors
Spot Light Installation
1. The spot light should be installed on flat, level, non-metal surface.
NOTE:
If the spotlight is installed on a metallic surface, there must be
at least
1-
1/4” clearance
between the spotlight and the metal surface in order to allow the operation of the wireless remote
(either version). See drawing #1 on page 4.
2. Use the foam gasket to mark the spotlight mounting holes and wiring access hole (1/2
” /12.70mm).
It is recommended that the hole pattern area be covered in masking or painter’s tape to prevent
spider cracking when drilling the mounting holes and the wiring access hole. See drawing #2 on
page 4.
3. Route the power wires through the wiring access hole in the gasket and deck (or flat surface).
4. Ensure that the foam gasket is properly placed and sealed then fasten the spotlight to the surface
using the user supplied four (4)
¼” (6mm) self-tapping screws, or the four ¼” bolts and nuts.
