36
To stop engine, fully release throttle le-
ver then depress the start/stop button
and disconnect safety lanyard from the
post.
All Models
1. Engine start/stop button
5) Variable Trim System
(VTS) Button
(if so equipped)
Located just below engine start/stop
button, this button is used to change
pump jet nozzle position and to adjust
ride to suit watercraft load and water
conditions.
1. VTS button
A VTS position indicator is included in
the information center gauge. See else-
where in this section.
6) Choke Lever
Carburetor-Equipped Models
The choke is provided to supply a rich-
er fuel/air mixture when starting a cold
engine.
Choke lever should be pulled and held to
operate. Lever will automatically return
to its normal position when released.
1. Choke lever
7) Shift Lever
(if so equipped)
A push-pull lever:
– forward
– neutral
– reverse.
CAUTION:
Never rev the engine at
high RPM in reverse.
WARNING
On models
without
O.P.A.S. direc-
tional control is reduced when the
throttle is released and lost when
engine is off.
WARNING
On models
with
O.P.A.S. direc-
tional control is reduced when the
throttle is released or when engine
is off.
F01L63Y
1
F01L62Y
1
WARNING
Shift lever should only be used
when the engine is idling and craft
is completely stopped. Do not use
as a grab handle.
WARNING
Only use reverse at slow speed and
for the shortest time possible. Al-
ways ensure the path behind is clear
of objects and persons including
children playing in shallow water.
1
F17L0GY
smo2004-002a.book Page 36 Thursday, August 21, 2003 2:54 PM
www.SeaDooManuals.net
