81
Reverse Gate
When shift lever is in forward position,
reverse gate should be in an upward
position and locked. With the shift le-
ver in neutral position, reverse gate
should be in intermediate position.
When shift lever is in reverse position,
reverse gate should be in downward
position. Refer to an authorized Sea-
Doo sport boat dealer if an adjustment
is necessary.
Deck Drain
Remove any obstruction(s) from deck
drain outlet.
TYPICAL
1. Driver‘s seat
2. Deck drain opening
Fuses
Accessories, Engine Electrical
System and Gauges
If a fuse is defective, replace by one of
the same rating.
If nothing at all is working, check that
the battery cut-off switch in the engine
compartment is in the ON position. Al-
so, check main fuses, connected to
battery cut-off switch inside port rear
storage compartment.
1. Main fuses
2. Automatic bilge pump fuse
Fuses for the electrical system of the en-
gine are mounted in the fuse block,
which is located in the engine compart-
ment.
Fuses for the engine electrical system
are located below the solenoid, as
shown below.
WARNING
Ensure the steering/jet pump noz-
zle operates freely from side to
side and is not stressing the steer-
ing cable.
WARNING
Ensure the shifter/reverse gate op-
erates freely and is not stressing the
reverse cable.
F23L0SY
1
2
WARNING
Do not use a higher rated fuse as
this can cause severe damage. If a
fuse has blown, the source of mal-
function should be determined
and corrected before restarting.
See an authorized Sea-Doo sport
boat dealer for servicing.
F23H02Y
1
2
lmo2005-007a_1.book Page 81 Wednesday, September 1, 2004 3:27 PM
Summary of Contents for Challenger*180
