MAINTENANCE PROCEDURES
F04H2SY
1
TYPICAL
1. Pull lens out
F04H2
T
Y
1
TYPICAL
1. Lift and remove bulb
Assembly is essentially the reverse of
removal procedures. However, pay
particular attention to the following:
Apply dielectric grease on new bulb
contact surface.
When installing the bulb under the up-
per terminal plate, it is possible that
the bulb remains loose. The cover will
compress the terminal plate against
the bulb at reinstallation.
Stern Light Bulb Replacement
Unscrew lens counterclockwise and
pull it out.
F04H2UY
1
TYPICAL
1. Unscrew then pull
Pull bulb to remove it.
F04H2VY
1
TYPICAL
1. Pull bulb out
Apply dielectric grease on new bulb
contact surface.
Assembly is the reverse of removal
procedure.
Stern Light Connector Lubrication
Apply dielectric grease on stern light
connectors as needed.
_______________
91
Summary of Contents for Islandia SE
