6
SUPCat|
SETUP: VALVES & PUMP
Using the Recessed Valves:
Remove the cap to access the
valve stem.
Caution:
Read warnings
on valve surround.
Press and turn the stem
counterclockwise so it can
pop UP. When the stem is up,
the valve is closed and will
hold air.
To let air escape for deflation,
press and turn the stem
clockwise until locked open.
Using the Double Action
Hand Pump:
In the double action mode
the pump inflates on the up
and down strokes. In the
single action mode, the
handle comes up more easily,
allowing the user to push
hard on the down stroke.
Screw the hose onto the
pump.
Begin In the double action
mode for fast fill.
Switch to single action when
handle becomes too hard to
lift.
SUPCat |
ASSEMBLY & INFLATION
Using the Double Action
Hand Pump:
The pump hose has a
Recessed Valve Adapter at
one end. When ready to
inflate the SUPCat, push
adapter firmly into valve and
twist clockwise to lock in.
If hose untwists itself from
valve, twist hose
counterclockwise an extra
half a turn and reinsert. Inflate
SUPCat after main board is
installed.
One-Time Assembly
Some items require one time assembly. Once installed they may
remain in place when stowing SUPCat10. The necessary hardware is
included.
Motor Mount Assembly
Motor Mount Kit:
2 - M8 x 45mm hex head bolts
2 - Flat Washers
2 - Lock Nuts
Wood motor mount block
Main Box
Main box contains two
inflatable SUP boards with
aluminum connecting tubes,
main aluminum board, motor
mount hardware, removable
floor, orange repair kit with
eight Scotty Pad Mount
screws, and hull bag.
Locate an area large enough to safely unfold SUPCat10. Check that
the area is free of hazards that could injure you or damage SUPCat.
Installation of the main aluminum board is easiest when pontoons are
deflated.
Tools needed: two wrenches or any combination of two 13mm
wrenches, nut drivers or adjustable wrenches. One philips head
screwdriver.
