11
FastCat14.4 | ASSEMBLY & INFLATION
Attach seat mounts to
frame board. Place seat
mount over the holes in
the bench so the screws go
through the bench. Place
washer and locking nut on
the screw. Hold screw with
phillips tip screwdriver and
tighten nut with 7/16” or
adjustable wrench.
Aluminum is relatively soft,
do not over tighten screws.
Seat Frame
Locate the aluminum seat
frame bars (35-½”), board
(47”) and quick connect seat
mounts.
Insert screws with washer
through the side chamber
grommets and transom
holes.
A wrench is recommended
for holding the bolt heads
while tightening the
threaded knob.
Seat Frame Assembly
FastCat14.4 can take up to
four seats with pedestals.
Seats are installed on alu-
minum Seat Frames.
Note: The pedestals can be
bolted directly to the frame
without a seat mount.
When all transom screws
have been inserted, inflate
the sides to working
pressure.
Caution:
Check
transom knobs before each
use. Tighten knobs if needed.
Adjustment Knobs
4 - ¼ x 1-¼” phillips head
screw
4 - threaded three-arm
knobs
Run screws up through
bottom of seat frame bar.
Use the middle hole for first
use. Spin knob onto screw
and tighten. Repeat for
remaining screws.
Locate the seat mounts and
hardware.
4 - ¼” x 2” flat head screws
4 - 5/8“ flat washers
4 - ¼” locking nuts
Insert screws through the
holes in the seat mount.
Not much air, the chamber
should be soft enough
to easily push it back and
forth.
