9
FishSkiff |
ASSEMBLY & INFLATION
Fishing Rig
To assemble and install the
Swivel Seat Fish Rig, please
refer to the supplemental
instructions on
page 16.
Seat Placement:
The locking seat should be
used by the motor
operator at all times.
Push the 100mm (4”) x M8
bolts with washer through the
grommets and transom.
If needed, push sides so
transom holes align with
grommet holes.
A wrench is recommended for
holding the bolt heads while
tightening the threaded knob.
When all four bolts are
inserted, inflate the side
chambers to the working
pressure.
Stand Up Paddle
This adjustable paddle
has a T-handle, shaft and
blade. Insert the blade
into the shaft and align
the hole with the button
to lock in place. Insert the
T-handle and adjust to
the desired length using
the locking nut.
Turn the large nut
counter clockwise to
loosen. Pull out the T-grip
to size. Turn nut clockwise
to tighten.
Adjust to your height.
Stand paddle on ground
with arm up. Handle
should fit in palm of hand
(about 9” above your
head).
Motor Mount Transom Board
Insert transom board into
motormount grommets.
Plate with ring faces
forward.
Start with floor grommets.
Adjust transom board to
align the holes.
WARNING:
Air compressors that are
designed for other uses
like tire inflation (usually
over 30 psi) can easily
over-inflate and cause
harm to your Sea Eagle
that uses a much lower
pressure. For this reason,
we recommend using
only Sea Eagle manual or
electric pumps.
Paddle Holder
Use clips to secure paddle
to boat. Extend handle
slightly and insert into
forward clip. Press and
twist paddle at blade end
to insert shaft in rear clip.
