3.7
S
ECTION
3 • U
SING
Y
OUR
B
OAT
270 Select EX
W
INDLASS
C
ONTROLS
(F
IG
. 3.7.1)
A. T
O
O
PERATE
F
ROM
THE
H
ELM
:
•
Make sure that the safety lanyard is removed
from the anchor chain.
•
Turn the WINDLASS
MAIN switch ON.
•
Push up on the
W I N D L A S S
CONTROL toggle
switch (located below
the control station
switch panel) to lower
the anchor. To raise
the anchor, push
down on the WINDLASS CONTROL toggle
switch.
Keep hands, feet, hair and loose clothing clear of
moving parts. Entanglement may cause severe bodily
injury (i.e. loss of fingers or toes).
!
WARNING
10. W
INDLASS
(O
PTIONAL
)
The windlass is wired to the 12 volt system through
the WINDLASS breaker on the Main DC Breaker
Panel located on the cockpit floor storage aft
bulkhead.
The windlass facilitates the anchoring of your boat
by automatically raising and lowering the anchor. To
operate the windlass the WINDLASS power switch
on the control station switch panel must be ON.
WINDLASS
MAIN
CONTROL
It is important that the windlass clutch is tight for
proper operation and safety. Periodically check the
clutch and tighten if necessary.
To Tighten Clutch:
With the anchor in the stowed
position, tighten the windlass clutch by inserting the
emergency handle into the clutch nut (see Fig. 3.10.1)
and turn clockwise.
NOTICE
W
INDLASS
S
AFETY
L
ANYARD
AND
C
HAIN
(F
IG
. 3.7.3)
SAFETY
LANYARD
W
INDLASS
(F
IG
. 3.7.2)
ANCHOR
CHUTE
SAFETY
LANYARD
PORTIONS OF THE DECK
REMOVED FOR CLARITY
Summary of Contents for 270 Select EX
