Sea Ray 290 Select EX, Owner'S Manual

61

290 Select EX

PREVENT THE DISCHARGE OF POLLUTANTS

DISCHARGE OF OIL OR OILY WASTE INTO NAVIGABLE WATERS IS
PROHIBITED OF SUCH A DISCHARGE CAUSES A FILM, SHEEN OR

A DISCOLORATION OF THE SURFACE, OR CAUSES A SLUDGE

OR EMULSION BENEATH THE SURFACE OF THE WATER.

VIOLATORS ARE SUBJECT TO PENALITIES.

MRP # 934539

SR-166

This tag replaces “Discharge Of Oil Prohibited”

tag under bilge access hatch when boat is

ordered with CE international option.

LOCATED UNDER BILGE ACCESS HATCH

C H E C K   B A T T E R Y   C E L L   F U E L
LEVEL APPROXIMATELY EVERY 4
W E E K S   A N D   M O R E   O F T E N   I N
SUMMER AND HOT ZONES.

MRP # 914341                                   SR-139

NOTICE

LEAKING FUEL IS A FIRE AND
EZPLOSION HAZARD, INSPECT SYSTEM
REGULARY. EXAMINE FUEL TANKS FOR
LEAKS OR CORROSION AT LEAST
ANNAULLY.

MRP # 852632                                   SR-151

WARNING

!

STAY CLEAR OF MOVING PARTS

WHILE ENGINE IS RUNNING

MRP # 852624                              SR-149

DANGER

!

DISCHARGE OF OIL PROHIBITED

THE FEDERAL WATER POLUTION CONTROL ACT PROHIBITS THE

DISCHARGE OF OIL OR OILY WASTE INTO OR UPON THE NAVI-

GABLE WATERS OF THE UNITED STATES OR THE WATES OF THE

CONTIGUOUS DISCOLORATION OF THE SURFACE OF THE WA-

TER OR CAUSES A SLUDGE OR EMULSION BENEATH THE SUR-

FACE OF THEWATER. VIOLATORS ARE SUBJECT TO A PENALTY

OF $5,000.

MRP # 258509

SR-44

S

AFETY

 L

ABEL

 L

OCATIONS

Main Deck

(fig.61.1)

Figures 61.1 thru 64.1 identify the safety labels and their location on your boat. Make certain they are all on your boat.
If any of these labels are illegible or missing, call 1-800-SRBOATS for free replacement labels.

MRP

 852533

SR

-119A

DANGER

!

NO SMOKING

GASOLINE VAPORS ARE EXPLOXIVE

NOTICE

GASOLINE RECOMMENDATION

Minimum octane rating of 87 AKI.

Refer to the engine owner’s manual for

additional information.

STAY CLEAR OF MOVING PARTS

MRP # 921759                              SR-162

LOCATED UNDER ANCHOR HATCH

DANGER

!

- READ THE INSTRUCTIONS BEFORE OPERATING

THE WINDLASS.

- KEEP HANDS AND FEET AWAY FROM GYPSY AND

CHAIN AT ALL TIMES.

- WHEN WINDLASS IS NOT IN USE OR BEFORE

USING THE HANDLE, TURN OFF THE WINDLASS
AT THE MAIN SWITCH.

- ENGAGE THE CHAIN STOPPER AFTER ANCHORING.

WINDLASS MUST NOT BE USED AS SOLE MEANS
OF SECURING ANCHOR IN BOW FITTING. ANCHORS
MUST BE INDEPENDENTLY SECURED TO PREVENT
ACCIDENTLY RELEASE.

- BE SURE THE CLUTCH AND THE CHAIN STOPPER

ARE WILL ENGAGED BEFORE SAILING.

WARNING

ON WINDLASS (MRP NUMBER PROVIDED BY VENDOR)

SLING

MRP #221861

SR-27

SLING

MRP #221861

SR-27

SLING

MRP #221861

SR-27

SLING

MRP #221861

SR-27

CAUTION

 - TO AVOID INJURY, GLASS DOOR MUST BE SECURED IN A

CLOSED AND LOCKED POSITION WHEN BOAT IS UNDER
WAY. USE BOTH TURN LOCKS TO SECURE DOOR.

ON WINDSHIELD FRAME (MRP NUMBER PROVIDED BY VENDOR)

MRP 811000

SR-102

DANGER

!

TRANSOM DOOR MUST BE

CLOSED AND SECURE WHEN

ENGINE IS RUNNING

MRP 852525

SR-111

WARNING

!

USE CAUTION WITH SKIER IN TOW

AS TOW ROPE MAY BACKLASH INTO

COCKPIT WHEN RELEASED

MRP 1112879

SR-214

DANGER

!

TO AVOID RISK OF SERIOUS INJURY OR

DEATH

SHUT OFF ENGINE WHEN NEAR SWIMMERS
OR PRIOR TO USING SWIM PLATFORM AND

BOARDING LADDER.

STAINLESS STEEL SLIDING SWIM LADDERS

SUGGESTED CARE & MAINTENANCE

MRP 1573112

SR-505

AFTER EACH USE:

Fully extend ladder and thoroughly rinse all ladder and slide surfaces with
fresh water. Pay special attention to flushing any debris and salt water from
the slide areas.

MONTHLY:

Examine the ladder slide grooves and remove any foreign particles lodged
within the grooves.

Wash entire ladder, uning 

ONLY 

a clean, soft cloth, and mild soap solution.

Rinse thoroughly with fresh water.  To prevent damage NEVER USE
ABRASIVES or ABRASIVE CLEANERS!

Allow ladder to dry after washing.  Apply a light coating of spray lubricant or
clear silicone grease to the slide areas 

ONLY

.  Work ladder back and forth

to assure distribution of lubricant and ease of operation.

CAUTION - TO PREVENT THE POSSIBILITY OF PERSONAL INJURY,
ENSURE THAT ANY LUBRICANT IS CLEANED FROM LADDER RUNGS
AND STILES PRIOR TO USE.

Inspect the ladder for damage and check the security of all fasteners.
Repair damage and/or tighten any hardware that may have become loose
prior to use.

INSTALLED UNDER SWIM LADDER HATCH

To minimize shock hazard, connect and disconnect cable

as follows;

1. Turn off boat’s shore power switch.

2. Connect cable at boat first.

3. If equipped with polarity indicator which activates,

disconnect and connect polarity.

4. Disconnect at shore outlet first.

5. Close inlet cover tightly.

DO NOT ALTER SHORE POWER CABLE CONNECTORS

   SHORE POWER

WARNING

ON SIDE OF HULL / WITH SHORE POWER OPTION

(MRP NUMBER PROVIDED BY VENDOR)