7.3
S
ECTION
7 • O
PTIONS
& A
CCESSORIES
300 Sundancer
®
(335 Sundancer
®
)
W
ATER
S
YSTEM
I
NSTALLATION
(F
IG
.7.3.1)
WATER HEATER
WATER HEATER
VENT
TRANSOM SHOWER,
DOCKSIDE WATER PICK-UP
& FRESH WATER WASHDOWN SPIGOT
WATER SYSTEM
MANIFOLD, WATER
PUMP & FILTER
WATER TANK
WATER TANK
VENT
COCKPIT WET BAR
HEAD SINK FAUCET/
SHOWER WAND
GALLEY FAUCET
PORT
STBD
FWD
liters)). You will need approximately one (1)
gallon of weak bleach solution for each fifteen
(15) gallons of tank capacity.
3. Prepare the proper amount of a weak bleach
solution by mixing 1/4 cup of unscented
household chlorine bleach per gallon of water.
4. Pour weak bleach solution into the water tank.
Remember, use about one (1) gallon of weak
bleach solution for each fifteen (15) gallons of
tank capacity.
5. Fill the remainder of the tank with fresh, clean
water. This will further dilute the weak bleach
solution.
6. Switch ON the water system switch, then turn
on the faucets and allow the air to be exhausted
from the plumbing system. By doing this, the
entire fresh water system will be filled with a
sanitizing solution.
7. Allow the sanitizing solution to stand in the water
system for three (3) hours.
8. Pump the water tank empty.
9. Fill the water system completely with fresh,
clean water. Turn on the faucet and permit the
entire contents of fresh, clean water to run
through the system. This will flush the sanitizing
solution out of the plumbing.
10. Fill the water system again, with fresh, clean
water, and turn on the faucet to permit the air to
dissapate.
Your water system is now sanitized.
Summary of Contents for 300 Sundancer
