Sea Recovery Aqua Whisper DX 1400-2 Owner'S Manual Download

Page: 102 / 226

Aqua Whisper DX Modular 450-1800

Page 6-6

Commissioning

Touch the HP Pump START button.

Slowly increase operating pressure by adjusting
the back pressure regulator valve knob in a
clockwise direction until the product water flow
reaches the System production rate.
a) If the high pressure exceeds 975 psi (67 bar),

an alarm will sound and shut down the System.

b) When production rate is reached, the System

will start monitoring the product water salinity.

Although the system is producing “Product
Water”, the Product Water may not be
“Potable” for up to 30 minutes. The salinity of
the Product Water diminishes gradually, until
it reaches the acceptable level or lower.

PRODUCT SALINITY (RED) simply means that the
dissolved solids in the Product Water have not yet
decreased to acceptable level.

PRODUCT SALINITY (GREEN) simply means that
the dissolved solids in the Product Water have
reached the acceptable level and the Diversion
Valve can be activated.

Activate the Diversion valve when Salinity meter
turns Green.
a). If the tank is not full and the salinity of the

product water drops below the preset salinity
level, the U.V. sterilizer will energize if installed.

b) Feed Pressure, Feed Flow, Operating Pressure,

Brine Flow, Product Flow, and Product Salinity
will be monitored and the System Control
Logic will perform various tasks to maintain
proper functioning of the System.

c). When the tank is full, the System will

stop all operations.

10. Check for:

a)  A constant feed water flow.
b)  A consistent system pressure.
c)  Leaks in the system.
d)  Abnormal noises or other occurrences.

11. If any abnormality develops, touch the STOP button

on the Touch Screen. A warning screen will display.
a) Correct the problem then repeat Step 1-10.

12. Proceed to Log System Readings.

3-way Diversion Valve will energize sending
the product water to the potable water outlet.

e) Feed Pressure, Feed Flow, Operating Pressure,

Brine Flow, Product Flow, and Product Salinity
will be monitored and the System Control
Logic will perform various tasks to maintain
proper functioning of the System.

f). When the tank is full, the System will stop

all operations.

Check for:
a)  A constant feed water flow.
b)  A consistent system pressure.
c)  Leaks in the system.
d)  Abnormal noises or other occurrences.

If any abnormality develops, a warning/error
screen will display.
a) Stop the System. correct the problem then

repeat Step 1-5.

Proceed to Log System Readings.

B. MANUAL MODE

The Manual Mode is intended for SRC technicians for
setup and configuration purposes.

NOTE

: The Remote Touch Screen will

be blocked during operation in the
Manual Mode.

CAUTION

: When the System is operated

in the MANUAL Mode Safety features will
still be controlled by the System Logic,
however AUTOMATED features will not
be controlled by the System Logic and
must be controlled by the operator.

Verify the back pressure regulator valve knob is in
fully open position.

From the default screen, touch the SETUP tab.

On the next screen, touch the Acceptable Salinity
Level button.

On the Salinity Level screen, adjust to desired level
(200 to 1000 PPM) then touch the SETUP button.

On the next screen, touch the Manual Mode button.

On the next screen, touch the Booster Pump
START button then wait 5 seconds for booster
pump to stabilize.