Sea Tel 9711-92 Installation And Operation Manual Download

Page: 85 / 196

9711-92 Ku-Band TXRX

Setup – Modem Connections, Setup and Test

12-1

12.

Setup – Modem Connections, Setup and Test

In order to be compliant with FCC Order 04-286 and WRC-03 Resolution 902, the Satellite Modem

MUST

be connected to the

ACU/TMS to provide TX Mute control functionality. The FCC/WARC requirements have been adopted by ITU and ETSI for

them to publish similar requirements. The current FCC/WARC requirements are:
Mute the Transmit output of the satellite modem used in TX/RX antenna configurations when the antenna is positioned where

people may be harmed by the transmit power emanating from the antenna (RF Radiation Hazard).
Mute the Transmit output of the satellite modem used in TX/RX antenna configurations when the antenna is mispointed by 0.5
degrees, or more, and keep it muted until the antenna is within 0.2 degrees of peak pointing to the satellite for a minimum of 5

seconds (FCC part 25.221 & 25.222 TX Mute requirement).
The connection will also provide External Modem Lock and GPS Latitude & Longitude.
The External Modem Lock output from a satellite modem into the ACU provides a positive Network ID input to the ACU when
the antenna is on the desired satellite.

This input is NOT used for tracking purposes

, it is only used for satellite

identification to assure that the satellite which has been acquired is the correct satellite (else the ACU will resume searching).
The GPS output from the ACU provides the current ships Latitude & Longitude as an input to the satellite modem for mobile
mode operation.
All modems must be set for mobile operation.

12.1.

Jumper Selection

JP1 – JP4 are used to couple in pull-up resistors for the below listed

functions. JP5 selects the DC voltage output on TS4.

JP1 SW1

– This output would be used for below decks Band Select -

to control a band selection switch or tone generator.

Default is

OPEN

Shorted provides DC Voltage output (determined by JP5 setting) on the
SW1 screw terminal to supply voltage to a tone generator or band

select switch.
Open provides continuity output (short to ground or open circuit) on

the SW1 screw terminal to control devices which have their own power

source.

JP2 SW2

(blockage & RF radiation hazard output) - Provides TX

Mute control to the Satellite Modem for FCC compliance in all VSAT
systems. It is also used to control antenna switching via a dual antenna
arbitrator in dual antenna configurations.

Default is SHORTED

when

blocked. The Blocked/Unblocked logic state can be reversed by

including SYSTEM TYPE 0016.
Shorted provides DC Voltage output (determined by JP5 setting) on the

SW2 screw terminal to supply voltage to the satellite modem when the

modem requires DC Voltage to Mute transmission. In dual antenna
configurations this used for dual antenna arbitrators that require DC

Voltage to switch. This hardware connection is also routed to the

Console and OBM RJ45 ports.
Open provides continuity output (short to ground or open circuit) on

the SW2 screw terminal to satellite modem when the modem requires

continuity control (short or open) to Mute transmission. In dual
antenna configurations this used for dual antenna arbitrators that

require continuity control (short or open) to switch. This hardware

connection is also routed to the Console and OBM RJ45 ports.