20
INSTALLATION OF POSITIVE STOPS
Ø
release the unit (as in fig. 23 of page 10)
Ø
Make the shaft come out for ¾ of its stroke
Ø
Put the positive stops into the front flange of the unit with the two tie rods (of the three present on the stops)
which are parallel to the gate (Fig.16)
Ø
Fix the positive stops with the provided screws
Ø
Only Mini Tank : Put the provided bush
(A)
into the shaft
Ø
at this point couple the shaft to the front bracket
Ø
To adjust the positive stops in opening act on disk 1 and in closing act on disk 2.
Attention: The mounting of the mechanical positive stops does not cause the reduction of the shaft stroke.
BREATHER SCREW
Up
down
OK
Fig. 17
Fig. 18
Unscrew and
remove at the
end of installation
ATTENTION
It is obligatory to remove the breather
screw at the end of the installation.
Fig. 16
(A)
rods parallel to the gate
Disco 1
Disco 2
MINI TANK
MARK TANK
Automazione Porte
e Cancelli
REV 01 - 07/2006
