28
PERIODICAL MAINTENANCE
1) Check the oil level in the hydraulic/oil-bath operators (cap placed inside Mini Tank or below release system for HT/FT)
2) Change the oil in case of low level
3) Check the release function
4) Check the by pass valve function
5) Check the fixing pin
6) Check the integrity of the connection cables
7) Check the function and the positive stops condition in opening and closing
8) Clean the hinge of the leaf and lubricate it with recommended lubricant
9) Verify, if installed, the battery back up system by disconnecting the power source (115V or 230V)
REMEMBER to turn on the power source after check
10) Check for all corroded parts and replace them
11) Check the tight of the hardware of the gate
12) Check the operating of all accessories, especially the functioning of all safety devices and
Position Gate
(if installed)
(GREASE GL 00 65000009)
13) Lubricate the shaft with SEA grease
All the above described operations MUST be made exclusively by an authorized installer
Fig. 55
ELECTRIC LOCK
PHOTOCELLS
RADIO RECEIVER
TRANSMITTER
EXTERNAL LOOP DETECTORS
KEY SWITCH
POSITIVE STOPS
FLASHING LAMP
BATTERY BACK-UP
MAGNETIC LOCK CARD
MAGNETIC LOCK
PALM JOLLY 3
LIBRA ACCESSORIES
RISK EXAMINATION
The points pointed by arrows
are potentially dangerous. The installer must take a thorough risk examination to prevent
in Fig. 55
crushing, conveying, cutting, grappling, trapping so as to guarantee a safe installation for people, things and animals. (
Re. Laws
in force in the country where installation has been made
). As for misunderstandings that may arise refer to your area distributor
or call our help desk. These instructions are part of the device and must
be kept in a well known place. The installer shall follow the provided
intructions thoroughly.
products must only be used to
SEA USA Inc.
automise doors, gates and lwings. Any initiative taken without
SEA USA
Inc.
explicit authorization will preserve the manufacturer from whatsoever
responsibility. The installer shall provide warning notices on not
assessable further risks.
in its relentless aim to improve the
SEA USA Inc.
products, is allowed to make whatsoever adjustment without giving notice.
This doesn’t oblige
to up-grade the past production.
SEA USA Inc.
SEA
USA Inc.
can not be deemed responsible for any damage or accident
caused by product breaking, being damages or accidents due to a failure
to comply with the instructions herein. The guarantee will be void and the
manufacturer responsibility will be nullified if
original spare
SEA USA Inc.
parts are not being used.
The electrical installation shall be carried out by a
professional technician who will release documentation as requested by the laws in force.
Packaging materials such as plastic
bags, foam polystyrene, nails etc must be kept out of children’s reach as dangers may arise.
