Bracket shoe
Lanyard bolt
Lanyard
hook
Tighten
smaller Hex wrench
Attaching the Optional Accessories
Arm
E-22
CAUTION
The Sea Arm VII system can be
attached by mounting the optional
Bracket Shoe (20100) on the hand
grips.
For Sea Arm VII system
The Sea Arm 8 system can be
attached by mounting the optional
Bracket Shoe (20100) or SA8 Fixed
Ball Base (22119) on the hand grips.
Use the smaller hex wrench (3mm) provided when removing the lanyard
bolts.
For Sea Arm 8 system
Attaching the Optional Accessories
Finder
E-21
1
2
CAUTION
Replacing the pick-up finder
Rotate the finder unit mounted on
the rear case in a counterclockwise
direction to remove it
The screw areas are coated in
grease, so be careful not to touch
them.
Rotate the replacement finder
unit in a clockwise direction to
attach it
Before attaching the finder, check to make sure that there is no dust, dirt,
or debris inside it.
When replacing the finder, do not touch the surface of the finder lens.
When replacing the pick-up finder, always refer to the instruction manual
provided.
CAUTION
When replacing the finder unit, always refer to the instruction manual
provided with the VF45 1.2x or VF180 1.2x.
Replacing the finder Unit
The optional VF45 1.2x (46111) or
VF180 1.2x(46112) enhances
magnification by 1.2x and enables
subtle framing and focusing of
subjects.
This product comes equipped with a 0.5x pick-up finder. The finder can
be replaced with an optional finder so you can change the finder magnifi-
cation to match your shooting conditions.
