E-14
Installing the Batteries
CAUTION
5
Verify that the [ ] mark
on the battery cap is lined
up with the [ ] mark
(Fig.3)
7
Turn the [ ] mark
clockwise to the [ ] mark
(Fig.4)
Turn until you hear the sound of it
clicking into place.
6
Align the battery cap with
the [ ] mark, and insert
the battery cap into the
strobe (Fig.3)
Check the O-ring to make sure
there are no scratches or debris.
Battery cap
Replace the batteries when it takes 30 seconds or more until the
Ready/TTL lamp illuminates in red after firing at full.
When installing or removing batteries, thoroughly wipe water
off the strobe and dry your hands. Pay particular attention not
to allow water from your hair or wetsuit to drip into the battery
compartment. This is in order to prevent an electrical hazard,
mold, malfunction or damage to the strobe.
Never mix old and new batteries or batteries of different types.
Always replace all batteries with new batteries at the same time.
Fig.3
Fig.4
〝
Click!
〟
