5
| P
age 32 | SEABOB Operator's Manual |
5.3.4 Information Display
The graphic display is divided into three fields. Dur-
ing operation of the craft, the following information is
shown on the Information Display:
Left field:
The current water temperature (in °C) is shown at the
top left of the display. Below, the current diving depth (in
m) is displayed.
Middle field:
The power display is located in the middle field. The
current motor speed is depicted graphically in the
speed range on the outer circle. The red dot in the speed
range shows the maximum power (Power Level) set in
the menu. The current power (Power Level) is shown
numerically and graphically in four successive segments
on the inner circle. The fourth segment (Power Level 4) is
shown in red; all of the preceding segments are shown
in white. The numerical display of the current power
in % of maximum power is displayed in the center of the
power display.
The current Power Level and the current power in % of
maximum power are set parallel to each other. The power
is set in increments of 25 % (4 Power Levels). Power is
increased by one Power Level by tapping the green but-
ton (+ 25 % driving performance) and decreased by one
Power Level by tapping the red button (- 25 % driving
performance).
Tip:
When the SEABOB is switched on, the set maximum
diving depth is shown at the bottom of the power display
for 5 seconds. This information then disappears again.
In the event of a malfunction, additional symbols may
appear in the middle field. Below is a list of these sym-
bols and their descriptions:
Warning symbol
• Motor temperature warning ("motor overheated")
➞
Power is limited to Power Level 2
• Battery temperature warning ("accumulator over-
heated")
➞
Power is limited to Power Level 2
• Warning: Battery error ("accumulator error")
➞
Emer-
gency operation! Power is limited to Power Level 2
Should the battery error re-occur or become permanent,
immediately halt operation and contact the manufac-
turer or your specialist dealer without delay.
• Warning: Impeller locked ("impeller locked")
➞
Motor stops
➞
see Chapter 7.4 "Impeller does not
turn (no thrust)"
Workshop symbol
• Warning: Water ingress into batteries or electron-
ics ("warning water ingress")
➞
Motor stops
➞
SEABOB switches to Off mode after 5 seconds
• Warning: System error ("system error")
➞
Trigger
or Control Grip error / internal communication inter-
rupted
➞
Motor stops
➞
Contact manufacturer or specialist dealer!
Right field:
In the right-hand field there is a battery symbol with in-
dividual bars showing the charge state of the SEABOB (1
bar = 10 % charge state). The numerical display of the
charge state (in % of full charge state) is located above
this symbol. The temperature of the battery (in °C) is
shown below the battery symbol.
Left
field
Middle
field
Right
field
Battery
temperature
(in °C)
Water
temperature
Diving depth
Set maximum
diving depth
Power (in % of
maximum power)
Power
Level
Speed range with red dot
for set maximum power
Battery
charge state
(in % of full
charge state)
