Cheetah X15 36LP Product Manual, Rev. D
59
9.6.4
Mating connectors
Part numbers for the different type connectors that mate with the various Cheetah X15 36LP I/O connectors
are given in the sections following.
9.6.4.1
Mating connectors for LW model drives
The nonshielded cable connector shall be a 68 conductor connector consisting of two rows of 34 male contacts
with adjacent contacts 0.050 inch (1.27 mm) apart.
Recommended mating flat cable connector part numbers are:
[1]
See Figure 20.
The drive device connector is a nonshielded 68 conductor connector consisting of two rows of 34 female pins
with adjacent pins 50 mils apart. The connector is keyed by means of its shape (see Figure 21).
9.6.4.2
Mating connectors for LC model drives
The nonshielded connector shall be an 80-conductor connector consisting of two rows of 40 contacts with
adjacent contacts 50 (1.27 mm) mils apart (see Figure 22). I/O connection using a cable is not recommended.
The length and size of the host equipment DC power carrying conductors from the DC power source to the
host equipment 80-pin disk drive interface connector(s) should be strictly designed according to proper power
transmission design concepts. No possibility for the equipment user to attach an 80-pin cable/connector should
be allowed, since the length of the DC power carrying conductors could not be controlled and therefore could
become too long for safe power transmission to the drive. Daisy-chain 80-conductor cables should especially
not be allowed, since the power-carrying conductors on the 80-conductor interface were not intended to sup-
port a series of drives.
To insure that both drive connector and host equipment mating connector mate properly, both drive connector
and host equipment mating connector must meet the provisions of “SFF-8451 Specification for SCA-2
Unshielded Connections.” See www.sffcommittee.org to obtain this specification.
Amp Model 786096-7
Female, 68-pin, panel mount
Amp Model 786090-7
Female, 68-pin, cable mount
Amp Model 749925-5
(50 mil conductor centers, 28 or 30 AWG wire)
Use two, 34 conductor, 50 mil center flat cable with this connector.
This type connector can only be used on cable ends. [1]
Amp Model 88-5870-294-5 W/O Strain Relief (25 mil conductor centers, 30 AWG wire).
Use either on cable ends or in cable middle section for daisy-chain
installations [1].
Amp Model 1-480420-0
Power connector 4 circuit housing
Berg 69307-012
12-position, 2 x 6, 2 mm receptacle housing
Summary of Contents for Cheetah X15 36LP ST318432LC
