C
ONSTELLATION
ES.3 SAS P
RODUCT
M
ANUAL
, R
EV
. C
12
5.0
R
ELIABILITY SPECIFICATIONS
The following reliability specifications assume correct host and drive operational interface, including all interface timings, power supply
voltages, environmental requirements and drive mounting constraints.
5.1
E
RROR RATES
The error rates stated in this manual assume the following:
• The drive is operated in accordance with this manual using DC power as defined in paragraph 6.3, "DC power requirements."
• Errors caused by host system failures are excluded from error rate computations.
• Assume random data.
• Default OEM error recovery settings are applied. This includes AWRE, ARRE, full read retries, full write retries and full retry time.
5.1.1
Recoverable Errors
Recoverable errors are those detected and corrected by the drive, and do not require user intervention.
Recoverable Data errors will use correction, although ECC on-the-fly is not considered for purposes of recovered error specifications.
Recovered Data error rate is determined using read bits transferred for recoverable errors occurring during a read, and using write bits
transferred for recoverable errors occurring during a write.
5.1.2
Unrecoverable Errors
An unrecoverable data error is defined as a failure of the drive to recover data from the media. These errors occur due to head/media or
write problems. Unrecoverable data errors are only detected during read operations, but not caused by the read. If an unrecoverable data
error is detected, a MEDIUM ERROR (03h) in the Sense Key will be reported. Multiple unrecoverable data errors resulting from the
same cause are treated as 1 error.
5.1.3
Seek errors
A seek error is defined as a failure of the drive to position the heads to the addressed track. After detecting an initial seek error, the drive
automatically performs an error recovery process. If the error recovery process fails, a seek positioning error (Error code = 15h or 02h)
will be reported with a Hardware error (04h) in the Sense Key. Recoverable seek errors are specified at Less than 10 errors in 10
8
seeks.
Unrecoverable seek errors (Sense Key = 04h) are classified as drive failures.
5.1.4
Interface errors
An interface error is defined as a failure of the receiver on a port to recover the data as transmitted by the device port connected to the
receiver. The error may be detected as a running disparity error, illegal code, loss of word sync, or CRC error.
5.2
R
ELIABILITY AND SERVICE
You can enhance the reliability of Constellation ES.3 disk drives by ensuring that the drive receives adequate cooling. Section 6.0
provides temperature measurements and other information that may be used to enhance the service life of the drive. Section 10.2 provides
recommended air-flow information.
Seek error rate:
Less than 10 errors in 10
8
seeks
Read Error Rates
1
1.
Error rate specified with automatic retries and data correction with ECC enabled and all flaws reallocated.
Recovered Data
Less than 10 errors in 10
12
bits transferred (OEM default settings)
Unrecovered Data
Less than 1 sector in 10
15
bits transferred
Miscorrected Data
Less than 1 sector in 10
21
bits transferred
Interface error rate:
Less than 1 error in 10
12
bits transferred
Mean Time Between Failure (MTBF):
1,400,000 hours
Annualized Failure Rate (AFR):
0.63%
Preventive maintenance:
None required
