SEAGO PREMIUM STAINLESS STEEL LIFTRAFT CRADLE
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE AND FIT YOUR CRADLE
The cradle can be mounted on a 25mm diameter push pit rail or alternatively can be
mounted to the deck through the holes on the frame using suitable fixings (not supplied).
Firstly, you should decide on a suitable location for fitting the cradle to allow for quick and
easy development of the liferaft in an emergency.
You must refer to your liferaft operating handbook / fitting instructions to make sure it
is fitted in a compatible way to your liferaft cradle.
In particular you should follow the operating handbook instructions for the correct
launching/deployment of your liferaft. Warning…prior to sailing the painter line on the
liferaft should be attached to a strong point on your vessel in accordance with your
liferaft operating instructions.
WARNING...
The secure assembly and fitting of this cradle is the responsibility of the
owner. Regular checks should be made to ensure that all the bolts and fittings are
tight and secure. No responsibility can be accepted for incorrect fitting or failure to
maintain the cradle and its fittings. These instructions are offered only as a guide and
should not be relied upon as being exhaustive or complete in any way.
IF YOU ARE IN ANY DOUBT AS TO THE CORRECT FITTING OF THIS CRADLE
YOU SHOULD SEEK QUALIFIED PROFESSIONAL ADVICE.
Before you start please ensure you have
all the correct fixings (see above).
