- 5 -
≥2
0c m
≥2
0c m
≥5
0 cm
≥5
0c
m
≥5
0c
m
- 6 -
B) The power outlet supply should be in accordance to the label on the rear of the
unit. The power outlet must be grounded.
C) Plug in the power cord into the supply outlet.
D) Check that the space around the air inlet/outlet is clear. There must be free air
flow for to op�mum performance and energy conserav�on.
E) To operate the Smart Dry in con�nuos mode the use of an external drain pipe is
needed. Follow these instruc�ons for con�nuos drain mode:
Connect 9mm drainage pipe to the hose connector and secure it to avoid any
leakage.
A) For best performance posi�on the unit in accordance to the below guideline.
Remove the
water tank
Connect drainage
pipe to outlet
Replace the water tank. The
drainage pipe will fit in the slot
on the water tank.
NOTE: For con�uous drainage to work the unit must always be higher than the
drainage pipe. The drainage pipe should not have any kinks, twists or knots and must
allow water to flow freely.
Summary of Contents for SMTD-201710V2EP
Page 1: ...User manual SMART DRY dehumidifier Model SMTD 201710V2EP ...
Page 2: ......
Page 3: ...1 1 3 3 4 5 6 7 8 9 10 11 12 ...
Page 16: ......
