DUAL ACE.
Instruction
Manual.
2
INTRODUCTION.
Thank you for choosing the
DUAL ACE
ARTF by SEAGULL MODELS. The
DUAL ACE
was
designed with the intermediate/advanced sport flyer in mind. It is a airplane which is easy to fly and
quick to assemble. The airframe is conventionally built using balsa, plywood to make it stronger than
the average ARTF , yet the design allows the aeroplane to be kept light. You will find that most of the
work has been done for you already.Flying the
DUAL ACE
is simply a joy.
This instruction manual is designed to help you build a great flying aeroplane. Please read this
manual thoroughly before starting assembly of your
DUAL ACE
. Use the parts listing below to
identify all parts.
WARNING.
Please be aware that this aeroplane is not a toy and if assembled or used incorrectly it is
capable of causing injury to people or property. WHEN YOU FLY THIS AEROPLANE YOU
ASSUME ALL RISK & RESPONSIBILITY.
If you are inexperienced with basic R/C flight we strongly recommend you contact your R/C supplier
and join your local R/C Model Flying Club. R/C Model Flying Clubs offer a variety of training
procedures designed to help the new pilot on his way to successful R/C flight. They will also be able
to advise on any insurance and safety regulations that may apply.
ADDITIONAL ITEMS REQUIRED.
!
.46cu.in 2 - stroke engine (2pcs).
!
Computer radio with seven digital
servos.
!
Glow plug to suit engine.
!
Propeller to suit engine.
!
Protective foam rubber for radio
system.
!
Silicone fuel line.
TOOLS & SUPPLIES NEEDED.
!
Thick cyanoacrylate glue.
!
30 minute epoxy.
!
5 minute epoxy.
!
Hand or electric drill.
!
Assorted drill bits.
!
Modelling knife.
!
Straight edge ruler.
!
2mm ball driver.
!
Phillips head screwdriver.
!
220 grit sandpaper.
!
90° square or builder’s triangle.
!
Wire cutters.
!
Masking tape & T-pins.
!
Thread-lock.
!
Paper towels.
PARTS LISTING.
FUSELAGE ASSEMBLY
!
(1) Fuselage.
!
(1) Canopy hatch.
WING ASSEMBLY
!
(1) Right wing half with pre-installed
aileron.
!
(1) Left wing half with pre-installed
aileron.
!
(1) Aluminium dihedral brace.
Tail section assembly
!
(1) Horizontal stabilizer with pre-
installed elevator halves.
!
(1) Vertical stabilizer with pre-
installed rudder halves.
Some more parts.
HARDWARE PACK
COWLING
Landing gear.....
