N E M E S I S
Instruction Manual.
26
4
.
5
.
6
.
Epoxy
Epoxy
7
.
Rudder fiberglass control horn.
INSTALLING THE HORIZONTAL
STABILIZER
Using a ruler and a pen, locate the cen-
terline of the horizontal stabilizer, at the
trailing edge, and place a mark. Use a tri-
angle and extend this mark, from back
to front, across the top of the stabilizer.
Also extend this mark down the back of
the trailing edge of the stabilizer.
Using a modeling knife, carefully re-
move the covering at mounting slot of
horizontal stabilizer ( both side of fuse-
lage).
Draw center line
Slide the stabilizer into place in the
precut slot in the rear of the fuselage.
The stabilizer should be pushed firmly
against the front of the slot.
Cut
1
.
2
.