N E M E S I S
Instruction Manual.
6
Before the epoxy fully cures, remove
the tape from around the control horn.
This will allow the epoxy to flow around
the control horn, creating a small filet
between the control horn and surface for
a fiished look and secure bond.
7
.
6
.
Epoxy
Because the size of servos differ, you
may need to adjust the size of the precut
opening in the mount. The notch in the
sides of the mount allow the servo lead to
pass through.
Place the servo between the mounting
blocks and space it from the hatch. Use
a pencil to mark the mounting hole loca-
tions on the blocks.
INSTALLING THE AILERON SERVOS
Use drill bit in a pin vise to drill the
mouting holes in the blocks.
1.5mm
3
.
4
.
2
.
1
.
20.0
Minimum servo spec.
Torque
: 6.0V: 192.4 oz-in (13.8 kg-cm)
7.4V: 350.0 oz-in (25.2 kg-cm)