www.seagullmodels.com
3
ADDITIONAL ITEMS REQUIRED.
0.61-0.75 cu.in 2-stroke
0.91-1.25 cu.in 4-stroke
Radio System required 4 channels
with 5 digital servos.
Glow plug to suit engine
Propeller to suit engine
Protective foam rubber for radio
system
Silicone fuel line
TOOLS & SUPPLIES NEEDED.
Thick cyanoacrylate glue
30 minute epoxy
5 minute epoxy
Hand or electric drill
Assorted drill bits
Modelling knife
Straight edge ruler
2mm ball driver
Phillips head screwdriver
220 grit sandpaper
90° square or builder’s triangle
Wire cutters
Masking tape & T-pins
Thread-lock
Paper towels
KIT CONTENTS
SEA14301 Fuselage
SEA14302
Wing set
SEA14303
Tail set
SEA14304
Fiberglass cowl
SEA14305
Landing gear
SEA14306
Canopy
SEA14307
Pilot
SEA14308
Fiberglass whl pants
SEA14309
Wheel
SEA14310
Aluminum wing tube
SEA14311
Engine mount
SEA14312
Fuel tank
SEA14313
Spinner
SEA14314
EP conversion pack
SEA14315
Hardware bag
2) Remove each hinge from the wing panel
and aileron and place a T-pin in the center of
each hinge. Slide each hinge into the wing
panel until the T-pin is snug against the wing
panel. This will help ensure an equal amount
of hinge is on either side of the hinge line when
the aileron is mounted to the aileron.
The control surfaces, including the
ailerons, elevators, and rudder, are
prehinged with hinges installed, but the
hinges are not glued in place. It is
imperative that you properly adhere the
hinges in place per the steps that follow
using a high-quality thin C/A glue.
Note:
HINGING THE AILERONS.
Hinge.
3) Slide the wing panel on the aileron until
there is only a slight gap. The hinge is now
centered on the wing panel and aileron.
Remove the T-pins and snug the aileron
against the wing panel. A gap of 1/64” or less
should be maintained between the wing panel
and aileron.
1) Carefully remove the aileron from one
of the wing panels. Note the position of the
hinges.
T-pin.
