Section 2. Operating Procedures
12
2. Pre-heat the Laminator
All Pre-heat control operations are controlled from the Control Panel as shown in
Figure 2.2
1. Switch machine to START at the
Main Power Switch
•
Laminator will power-up
•
Dryer Panel is in the UP position.
•
Heaters are OFF.
Figure 2.2 Heater Control locations
2. On the Heater Controller, press and hold the
SET
button to check the set-point
temperature. Adjust the set point by holding the
SET
button down and using the
UP/DOWN arrows to scroll to the desired temperature setting.
Note:
Most vinyl’s run well with a SET POINT temperature of 315°
C
(600°F)
dependent on speed.
3. Press the Heater Switch to ON to power the Dryer Panel and begin heating.
4. Once the machine reaches its SET POINT it is ready to be operated.
Set Button
Up Button
Down Button
Summary of Contents for AquaSEAL AS-1600
Page 19: ...Section 3 Troubleshooting 18...
