9
S A F E T Y F E A T U R E S
The SEAL
®
Image
®
410 Laminator is designed with
safety and protective devices with the user’s safety of
utmost consideration. However, following safe
operating guidelines is still the responsibility of the
operator.
P
OWER
D
ISCONNECT
S
WITCH
:
Located on the left stand leg (facing front of laminator),
it automatically shuts the laminator power off when the
power disconnect switch is turned to the OFF position.
WARNING! Authorized service technicians must
disconnect the power by using the power
disconnect switch before any servicing.
S
IDE
P
LATE
C
OVERS
:
The Side Plate Covers house the inner workings of the
laminator that maintenance or safety personnel can
open only with an Allen wrench.
WARNING! Use of the inside of the Side Plate
Covers for storage may cause possible personal
injury and/or damage to the inner workings and
will void the warranty.
H
AND
-O
PERATED
E
MERGENCY
S
TOP
B
UTTONS
:
Emergency Stop buttons are located on the top of each
of the side plate covers for easy access. Once pressed,
they immediately cease the laminator’s operation and
raise the top roller. Use these only in the case of an
emergency or you may damage an image during a
process.
NOTE:
Once pressed, these buttons lock and must
be turned clockwise to reset.
After resetting the Emergency Stop button, you must
turn the main power and the heaters back on (if being
used), and press the Motor Button ON to begin
processing again.
NOTE: If the Emergency Stop is depressed, the
machine will default to Program 1 upon restart.
C
OVERED
F
OOT
S
WITCH
:
The foot switch allows for complete user control when
initially feeding an image into the nip or for feeding a
delicate image through the rollers. The cover prevents
accidentally stepping on the foot switch and starting the
laminator.
WARNING! On Domestic version laminators the
foot switch overrides the photoelectric eyes. When
the photo eye is blocked, a Flashing Light and a
BUZZER sounds, warning of close proximity to the
nip. Use care to keep hands clear of the rollers
while using the foot switch to prevent possible
injury.
P
HOTO
E
LECTRIC
S
AFETY
E
YES
:
A light beam path set directly in front of the laminating
roller opening prevents foreign objects from passing
between the rollers. (The eyes are set for use at the
factory and checked by the service representative.)
If the photo-eye is blocked when lowering the top
roller, there will be an audible alarm and the top roller
will not move down. To allow the top roller to continue
movement, the operator must clear the nip and then
press the Nip Adjustment Button DOWN arrow. The
roller will proceed to lower to the desired setting.
NOTE! This function can only be overridden by
using the footswitch.
R
EVERSE
B
UTTON
:
The Reverse Button allows the rollers to be reversed if
there is a wrap around the enclosed pull rollers. The
Reverse Mode is operational when the motor is Off and
the footswitch is used.
WARNING! Keep hands clear of the pull rollers’
nip when using the Reverse Button. This button
can only be used in conjunction with the footswitch
and while operating at a slow speed of 1 fpm
(.3mpm). The speed cannot be adjusted.
