62
Cleaning the recovery tank and fresh water tank
Wash out the motor protection filter
Washing out the filter housing and the float
Cleaning / Replacing the brush roller
Replacing the brush roller
• Rinse the recovery tank and the fresh water tank thorough
-
ly with clean water.
• Remove the motor protection filter
from the transparent filter protection
above the filter housing.
• Wash out the motor protection filter
under running water.
• After washing it out, squeeze the mo
-
tor protection filter so that the water
can flow out.
Attention:
Do not reinsert the motor protection filter
before it is completely dry.
M A X
WATER LEVEL
LIVELLO ACQUA
WASSER NIVEAU
NIVEAU DE L`EAU
NIVEL DE L`AGUA
Temperature
+5°C + +35°C
+41°F + +95°F
2
3
1
1
2
• Remove the motor protection filter from the filter protection
before you wash out the filter housing.
• Wash out the filter housing and the
float (X), which is located on the un
-
derside of the filter housing, under
running water.
• Reinsert the dry motor protection fil
-
ter.
• Place the filter housing on the tank
and lock it into place.
Attention:
Danger of injury due to sharp objects.
Wear gloves for your own protection!
Notice:
Check the brush roller for wear after every
use.
Bristles that are too short or a damaged
brush roller could lead to damage to the
floor and impair the cleaning result!
• Place the machine on its side so that
the brush holders on the side are
pointing upwards.
• Press the rotation lock (1) and turn
the brush holder (2) counterclock
-
wise and pull it out of the housing (3)
in order to remove it.
• Take out the brush roller.
• Clean the brush roller under running
water.
x
2
1
2
1
3
