F R M - 1 0 1 0 I N S T R U C T I O N M A N U A L
16
4.
Install Ink Roller into the Ink Roller Holder.
Remove the metal ring found on the ink roller
holder using an allen wrench. Place the ink roller onto the ink roller holder and place the metal
ring back on the ink roller holder to hold the ink roller in place. Please note that for 30mm wide
ink roller, the metal ring will not be used.
Figure 20.
Remove metal wring found on the ink roller holder
Figure 21.
Ink roller installed on ink roller holder
5.
Insert Ink Roller in the Ink Wheel Heating Block.
When inserting the ink roller, ensure the
ink roller lines up with the type on the printing wheel. If the ink roller is pushed in too far, the
printing wheel will not print correctly.
Note: Do not allow the ink roller to heat continuously when machine
is not in use as heating block may melt the ink roller.
Figure 22.
Correct Ink Roller Position
Figure 23.
Incorrect Ink Roller Position
Test the ink roller position relative to the printing wheel. Place your finger under the
photoelectric sensor
Figure 40, Item #29)
. The sensor light will turn green and allow the
printing wheel to rotate.
6.
Make Adjustments to Ink Wheel Adjusting Device.
As the print wheel rotates, check that
the printing wheel makes contact with the ink roller. Make adjustments using the ink wheel
adjusting device
, Item #5)
if necessary. Turning the adjusting screw clockwise will
move the ink roller away from the print wheel and turning the adjusting screw counterclockwise
will move the ink roller closer to the print wheel.
Summary of Contents for Impresse FRM-1010
