10
© Sealevel Systems, Inc. 3541 Manual | SL9150 12/2022
files both explains typical Linux serial implementations and informs the user about Linux syntax and
preferred practices.
User can use a program such as 7-Zip to extract the tar.gz file.
In addition, the software selectable interface settings can be accessed by referencing
seacom/utilities/3541mode.
For additional software support, including QNX, please call Sealevel Systems’ Technical Support, (864) 843-
4343. Our technical support is free and available from 8:00 AM - 5:00 PM Eastern Time, Monday through
Friday. For email support contact:
Physical Installation
Do not install the Adapter in the machine until the software has been fully installed.
Extreme care should be taken when installing the adapter
to avoid causing damage to the connectors. After
the adapter is installed, connect your I/O cable to P1. Please note these headers are keyed so that pin 1 of
the cable matches pin 1 of the connector. Refer to Card Setup for information on setting the address and
IRQ before inserting the
adapter
onto the stack.
1.
Turn off PC power. Disconnect the power cord.
2.
Remove the case cover (if applicable).
3.
Gently insert the adapter
noting proper key orientation of the expansion connector on a PC/104
compatible card. The adapter is keyed per the current PC/104 Specification. This will aid in
preventing the adapter from being inserted incorrectly.
4.
Mounting hardware (nylon stand-offs and screws) is provided to ensure a good mechanical
connection. Retain any mounting hardware not used to allow for future expansion.
5.
The cables provided are keyed and can be installed before or after the adapter is inserted in
the stack.
6.
Replace the cover.
7.
Connect the power cord and power up the machine.
Installation is complete
