30
© Sealevel Systems, Inc. SeaConnect 370 Manual | SL9269 11/2022
Figure 19: Events page
The SeaConnect 370 does not have any events programmed by default. In order to send the
value of an
input to SeaCloud, you must create an event to send that input.
Event Deletion
To delete events, select the checkbox to the left of the desired event(s) and click the “Delete
Selected Event(s)” button.
About
The About page shows information related to copyright and technical support (Figure 20).
Figure 20: About page
Entering Access Point Mode Manually
To enter Access Point (AP) mode manually, hold down the configuration button while applying power to
the SeaConnect 370. The Status LED will blink twice to confirm this setting. Release the configuration
button immediately once you see the Status LED blink twice.
If any Wi-Fi- profiles have been defined, the SeaConnect 370 will default to Infrastructure Mode
upon each subsequent boot. To default to AP mode, remove all Wi-Fi profiles or reset the settings
to factory defaults.
